Dispose Multiple Defects

As a Quality engineer, you can dispose multiple defects at once by creating a plan.

Create a Plan

Note: A plan can only be created in NC view.
Enter the plan number in the search bar. The plan is added to the queue in the Home page.
Select the plan number from the queue. All the defects associated with the plan appear on the Home page
Select .
The Disposition page appears. The disposition page displays the number of defects being disposed.

In the???Select Disposition???drop-down list, select an option as described the following table.

Option	Description
Clear	Select???Clear???if the defects raised for the non-conforming parts are not considered as defects.
Continue to process	Select???Continue to process???to allow operation on the non-conforming parts and then select the operation till which you can continue the operations process, in the???Select operation???drop-down list box.
Use as is	Select???Use as is to use the non-conforming parts in the operations as they are.
Scrap	Select???Scrap???to discard the non-conforming parts.
Rework	Select???Rework???to rework on the non-conforming parts and then select the operation on which the parts should be reworked, in the???Select operation???drop-down list box.

The???Select reasons???window appears.

In the???Select reasons???window, select a corrective disposition action reason and the associated sub reasons, as applicable.

Tip: In the???Search???box, enter a disposition action reason to search for, and then select the reason from the reasons list.
Optional:???In the???ADDITIONAL INFORMATION???box, enter any relevant information such as a URL, contact details of the supplier, or any information that is helpful to perform the root cause analysis of the non-conformance.
Select???Submit.

The status of the defects is changed based on the selected disposition method. For more information, refer to Results section of Dispose of a Single Defect topic.