Provide the Completed Quantity for an Operation

About this task

After you perform an operation on a lot, you can provide the quantity of the lot on which you have performed the operation.

You can provide the completed quantity only if the following conditions are satisfied:
  • The operation requires clocking on (as defined in Route Editor or the ERP system).
  • You have specified the BOM consumption for all the mandatory BOM items for the quantity of lot that you want to mark complete. For example, in a lot of eight items, if you have performed the operation on two items, you must specify the BOM consumption for the two items. The quantity of the consumed BOM items must be greater than or equal to the required quantity to perform the operation.
  • You have provided data for all the mandatory quality variables for all the lots that you want to mark complete.
  • The lots are clocked on by you.

Before you begin

Perform the following steps for all the lots for which you want to provide the completed quantity:

Procedure

  1. In the row containing the operation for which you want to provide the completed quantity, select .
    Note: The button appears only if there is at least one lot that for which you can provide the completed quantity.
    The Select Serial/Lot number(s) to Record Quantity window appears, displaying a list of lots for which you can provide the completed quantity. In the COMPLETED column, the quantity of the completed lots (out of the planned quantity) appears.
  2. For each lot for which you want to provide the completed quantity, select the check box, and then enter the quantity in the REC QUANTITY column. The quantity that you enter must be less than or equal to the available quantity.
    Tip:
    • If you want to provide the completed quantity for all the lots in the list, select the check box in the heading row of the table.
    • You can search for a lot by entering a value in the Search in clocked on serial numbers box, and then selecting the check boxes from the filtered list that appears.
  3. Select Record.
    Tip: If you also want to clock off the selected lots, select Rec + Clock Off.
    Note: The Record and Rec + Clock Off buttons are enabled only if you select the check box for at least one lot.

Results

The value in the COMPLETED column for the operation is updated. If the completed quantity of a lot is equal to the planned quantity, the operation is marked complete for the lot.