Open topic with navigation

Send Data to a Datalogger

Before You Begin

• Install the on the machine that you will use with dataloggers. If you do not install it, when you attempt to send or receive data, you will be prompted to install it.
• Refer to the limitations when using a datalogger.
• If needed, modify the datalogger settings.

Steps

1. Access the TM Dataloggers page.

2. At the top of the page, in the drop-down list box, select the datalogger to which you want to send data. By default, the datalogger that you previously used is selected.

3. In the Send To section, in the rows containing the TMLs whose data you do not want to send to the datalogger, clear the check boxes.

4. Select Send.

   At the end of the section, changes to to indicate that the device is connected.

   If the data related to an asset was already sent to the datalogger previously, a message appears, asking you to confirm whether you want to overwrite the existing data on the datalogger. If you choose to overwrite, the data related to the asset is replaced with the data that you send. If you choose not to overwrite, the data will not be sent to the datalogger.

   The date is sent to the datalogger. When the operation is complete, changes to .

Copyright © 2018 General Electric Company. All rights reserved.