Open topic with navigation

Copy a Protective Instrument Loop Sensor

Note: Copying a Protective Instrument Loop Sensor alters the calculations for the protective instrument loop. Therefore, you must verify the calculations again.

Before You Begin

• Create a Protective Instrument Loop.

Steps

1. Access the Protective Instrument Loop Sensor that you want to replace.

2. In the upper-right corner of the datasheet, select Copy.

   The Search window appears.

   

3. In the upper-right corner of the window, select .

   A list of Protective Instrument Loop Sensors appears.

   

4. Select the check box that corresponds to the Sensor that you want to copy, and then select OK.

   The Protective Instrument Loop Sensor is copied.

Results

• The values in each field of the copied record are overwritten by those of the original record that you copied.
• The value in the Sensor ID field in the copied record is appended with a 1.

• Copying a record alters the calculations for the loop. The GE Digital APM system performs the calculations again.

What's Next?

• Access the Results of a Protective Instrument Loop

Copyright © 2018 General Electric Company. All rights reserved.